Lighting control for cannabis cultivation farms in DALI lines for LED lighting
Model: EN-CDC-General SA
The lighting control for cannabis growing is designed to control the LED lighting and is suitable for installation in the lighting control panel/switchboard.
The technological solution by our development team makes it possible to control the lighting intensity in the cannabis greenhouses and increases the treatment efficiency while growing the plant, managing the lighting 24 hours a day.
With the lighting control for the cannabis greenhouses, smart and safe control of the lighting intensity in the growing process and improvement in the plant’s output can be achieved while efficiently configuring the lighting intensity.
The controller is modular and includes 4 DALI communication channels operating up to 256 end units (lighting fixtures’ DALI addresses), to increase the amount of digital addresses additional controllers can be added according to the design requirements and without restriction.
The controller is used for bilateral data transmission, and to control the lighting fixtures’ operating systems. The data are transmitted by wired communication and enable, execution: On, off, dimming and indication of a “bulb fault” from the lighting fixtures. The communication in this method is carried out between the controller and the lighting fixtures directly.
The controller allows proper communication with the flashlights to a line length of up to 300 meters between the switchboard and the farthest flashlight. For longer distances, a communication amplifier must be installed on the lighting pole.
(optional). The controller also allows connection to a structure control system
Fault protection:
An active protection against fault voltage is installed on the DALI communication channel outputs. When connecting a mains voltage to the communication line, the active protection will block the high voltage and will not damage the system components. When the fault voltage is removed, the communication adapter will return to function without the need to replace it.
Technical data:
- Feed: 24VDC.
- Ambient temperature: (-30 ° C) – 75 ° C
- RS232 communication interface
- Digital inputs: 24V 5* I/O
- NO outputs (dry contact): 3, contact current – 250VAC 3A
- CO outputs (dry contact): 1, contact current – 250VAC 3A
- Mechanical measurements (mm): L=160 x H=59 x W=91
- Installation: On 9M DIN rails.
For LED lighting control consulting/planning for for a cannabis growing farm please leave details and our representative will get back to you soon.
